;-----------------------------------------------------------------------------\
; ADCP Command File for use with VmDas software.
; 
; ADCP type:     75 Khz Broadband
; Setup name:    default
; Setup type:    Low resolution, long range profile(broadband processing)
; 
; NOTE:  Any line beginning with a semicolon in the first 
;        column is treated as a comment and is ignored by 
;        the VmDas software.
;
; NOTE:  This file is best viewed with a fixed-point font (eg. courier).
; Modified Last: 12August2003
;----------------------------------------------------------------------------/

; Restore factory default settings in the ADCP
cr1

; set the data collection baud rate to 38400 bps, 
; no parity, one stop bit, 8 data bits
; NOTE:  VmDas sends baud rate change command after all other commands in 
; this file, so that it is not made permanent by a CK command.
cb611

; Set for reduced bandwidth (extended range) profile mode (WB,WM), single-ping ensembles 
; (WP), forty (WN) 08 meter bins (WS), 4 meter blanking distance (WF), 330 cm/s 
; ambiguity vel (WV)
WB1
WM1
WP00001
WN040
WS0800
WF0400
WV0330

; Enable single-ping bottom track (BP), 
; Set maximum bottom search depth to 800 meters (BX) 
BP001
BX8000

; output velocity, correlation, echo intensity, percent good
WD111100000

; Two seconds between bottom and water pings
TP000200

; Four seconds between ensembles
; Since VmDas uses manual pinging, TE is ignored by the ADCP.
; You must set the time between ensemble in the VmDas Communication options
TE00000400

; Set to calculate speed-of-sound, no depth sensor, external synchro heading 
; sensor, no pitch or roll being used, no salinity sensor, use internal transducer 
; temperature sensor
EZ1020001

; Output beam data (rotations are done in software)
EX00000

; Set transducer misalignment (hundredths of degrees)
EA04150

; Set transducer depth (decimeters)
ED00040

; Set Salinity (ppt)
ES34

; save this setup to non-volatile memory in the ADCP
CK