;-----------------------------------------------------------------------------\ ; ADCP Command File for use with VmDas software. ; ; ADCP type: 300 Khz Workhorse ; Setup name: default ; Setup type: Low resolution, long range profile(broadband processing) ; ; NOTE: Any line beginning with a semicolon in the first ; column is treated as a comment and is ignored by ; the VmDas software. ; ; NOTE: This file is best viewed with a fixed-point font (e.g. courier). ; Modified Last: 12August2003 ;----------------------------------------------------------------------------/ ; Restore factory default settings in the ADCP cr1 ; Turning off the recorder CF11110 ; set the data collection baud rate to 38400 bps, ; no parity, one stop bit, 8 data bits ; NOTE: VmDas sends baud rate change command after all other commands in ; this file, so that it is not made permanent by a CK command. cb611 ; Set for reduced bandwidth (extended range) profile mode (WB,WM), single-ping ensembles ; (WP), fifty (WN) 4 meter bins (WS), 3 meter blanking distance (WF), 330 cm/s ; ambiguity vel (WV) WB1 WM1 WP00001 WN050 WS400 WF300 WV330 ; Enable single-ping bottom track (BP), ; Set maximum bottom search depth to 300 meters (BX) BP001 BX3000 ; output velocity, correlation, echo intensity, percent good WD111100000 ; One half second between bottom and water pings TP000050 ; One second between ensembles ; Since VmDas uses manual pinging, TE is ignored by the ADCP. ; You must set the time between ensemble in the VmDas Communication options TE00000100 ; Set to calculate speed-of-sound, use internal depth sensor (if available), use internal ; compass heading sensor, use internal pitch or roll being used, no salinity sensor, use ; internal transducer temperature sensor EZ1111101 ; Output beam data (rotations are done in software) EX00000 ; Set magnetic compass offset or compass bias offset (hundredths of degrees) EB00000 ; Set transducer depth (decimeters) ED00000 ; Set Salinity (ppt) ES35 ; save this setup to non-volatile memory in the ADCP CK