;-----------------------------------------------------------------------------\
; ADCP Command File for use with VmDas software.
; 
; ADCP type:     38 Khz Ocean Observer
; Setup name:    default
; Setup type:    Low resolution, long range profile(narrowband)
; 
; NOTE:  Any line beginning with a semicolon in the first 
;        column is treated as a comment and is ignored by 
;        the VmDas software.
;
; NOTE:  This file is best viewed with a fixed-point font (eg. courier).
; Modified Last: 12August2003
;----------------------------------------------------------------------------/

; Restore factory default settings in the ADCP
cr1

; set the data collection baud rate to 38400 bps, 
; no parity, one stop bit, 8 data bits
; NOTE:  VmDas sends baud rate change command after all other commands in 
; this file, so that it is not made permanent by a CK command.
cb611

; Set for broadband single-ping profile mode (WP), forty (WN) 24meter bins (WS),
; 16 meter blanking distance (WF), 390 cm/s ambiguity vel (WV)
NP0
WP00001
WN040
WS2400
WF1600
WV390

; Disable single-ping bottom track (BP), 
; Set maximum bottom search depth to 2000 meters (BX)
BP000
BX20000

; output velocity, correlation, echo intensity, percent good
WD111100000

; Two seconds between bottom and water pings
TP000200

; Two seconds between ensembles
; Since VmDas uses manual pinging, TE is ignored by the ADCP.
; You must set the time between ensemble in the VmDas Communication options
TE00000200

; Set to calculate speed-of-sound, no depth sensor, use internal compass heading 
; sensor, use internal pitch or roll being used, no salinity sensor, use internal 
; transducer temperature sensor
EZ1011101

; Output beam data (rotations are done in software)
EX00000

; Set magnetic compass offset or compass bias offset (hundredths of degrees)
EB00000

; Set transducer depth (decimeters)
ED00000

; Set Salinity (ppt)
ES35

; save this setup to non-volatile memory in the ADCP
CK